Furnace & Heating Repair — Jacksonville, FL
Two things matter when you call a furnace & heating repair: how fast they show up, and whether they fix it the first time. We try hard at both. We work clean, leave the area better than we found it, and stick around to test the repair before we drive off.
The actual work
Heating-side repairs run different than AC. Most furnace calls come down to ignitor failure, flame sensor, control board, or pressure switch. Heat pumps add reversing valve and defrost board.
Gas furnace ignitor failures are the most common winter call — about 40% of no-heat calls. The ignitor is a $35 part and a 20-minute job; total flat-rate runs $185-$340.
Heat pump no-heat in cold weather usually means failed reversing valve solenoid (system stuck in cool mode) or failed defrost board (outdoor coil iced up). Both diagnoseable in under an hour.
Older furnaces (15+ years) develop heat exchanger cracks. We check for them every diagnostic visit because a cracked heat exchanger leaks carbon monoxide and is a replacement-not-repair issue.
Pricing
For furnace & heating repair jobs in the Jacksonville area:
- Diagnostic visit: $80 – $120
- Hot surface ignitor replacement: $170 – $315
- Flame sensor replacement: $150 – $270
- Pressure switch replacement: $200 – $385
- Control board replacement: $385 – $780
- Heat exchanger replacement: $1,655 – $3,130
Notes on Jacksonville housing stock
We don't subcontract Jacksonville work. Every job is our own crew, our own trucks, our own warranty.
Most of our Jacksonville furnace & heating repair jobs come from older neighborhoods, where the housing stock just has more failure points.
Other services we run in Jacksonville
- AC Installation & Replacement in Jacksonville
- AC Repair in Jacksonville
- AC Maintenance & Tune-Ups in Jacksonville
- Ductwork Cleaning, Sealing & Repair in Jacksonville