Furnace & Heating Repair in Memphis, TN

Whether you saw water on the floor or just heard a drip, what happens in the next 30 minutes matters. Stop reading and call if it's the first one. Most of our work comes from neighbors of past customers. That's the only marketing we trust.

Phone: (800) 555-3072

What's typical for this job

Heating-side repairs run different than AC. Most furnace calls come down to ignitor failure, flame sensor, control board, or pressure switch. Heat pumps add reversing valve and defrost board.

Gas furnace ignitor failures are the most common winter call — about 40% of no-heat calls. The ignitor is a $35 part and a 20-minute job; total flat-rate runs $185-$340.

Heat pump no-heat in cold weather usually means failed reversing valve solenoid (system stuck in cool mode) or failed defrost board (outdoor coil iced up). Both diagnoseable in under an hour.

Older furnaces (15+ years) develop heat exchanger cracks. We check for them every diagnostic visit because a cracked heat exchanger leaks carbon monoxide and is a replacement-not-repair issue.

Local context for Memphis

Property managers across Memphis keep us on speed-dial because we're predictable. Same crews, same pricing, no surprises.

Most of our Memphis furnace & heating repair jobs come from older neighborhoods, where the housing stock just has more failure points.

Pricing

For furnace & heating repair jobs in the Memphis area:

Related work

One we ran last year

Last spring we got a call from a homeowner near the north Memphis. Furnace clicking but not igniting. Diagnosis: failed hot surface ignitor. We replaced ignitor, system back online in 30 minutes, ran the test, and were out the door in about two hours. Total: $1012 including parts.

Call (800) 555-3072