Furnace & Heating Repair — Atlanta, GA
Whether you saw water on the floor or just heard a drip, what happens in the next 30 minutes matters. Stop reading and call if it's the first one. What you get with us: licensed work, upfront pricing, a tech who can read what's wrong before opening up a wall.
Recent service example
Recent Atlanta job: heat pump blowing cold air in 28°F weather in a 12-year-old home. We replaced solenoid coil, recommissioned after diagnosing failed reversing valve solenoid. Cost ran $496 — pretty middle-of-the-road for that fix.
What this service includes
Heating-side repairs run different than AC. Most furnace calls come down to ignitor failure, flame sensor, control board, or pressure switch. Heat pumps add reversing valve and defrost board.
Gas furnace ignitor failures are the most common winter call — about 40% of no-heat calls. The ignitor is a $35 part and a 20-minute job; total flat-rate runs $185-$340.
Heat pump no-heat in cold weather usually means failed reversing valve solenoid (system stuck in cool mode) or failed defrost board (outdoor coil iced up). Both diagnoseable in under an hour.
Older furnaces (15+ years) develop heat exchanger cracks. We check for them every diagnostic visit because a cracked heat exchanger leaks carbon monoxide and is a replacement-not-repair issue.
Local context for Atlanta
We don't subcontract Atlanta work. Every job is our own crew, our own trucks, our own warranty.
Price expectations
For furnace & heating repair jobs in the Atlanta area:
- Diagnostic visit: $80 – $120
- Hot surface ignitor replacement: $170 – $315
- Flame sensor replacement: $150 – $270
- Pressure switch replacement: $200 – $385
- Control board replacement: $385 – $780
- Heat exchanger replacement: $1,655 – $3,130