Furnace & Heating Repair services in Arlington
Whether you saw water on the floor or just heard a drip, what happens in the next 30 minutes matters. Stop reading and call if it's the first one. Calls go to a working tech, not a call center. You'll get a real estimate over the phone when we can give one.
What you're paying for
Heating-side repairs run different than AC. Most furnace calls come down to ignitor failure, flame sensor, control board, or pressure switch. Heat pumps add reversing valve and defrost board.
Gas furnace ignitor failures are the most common winter call — about 40% of no-heat calls. The ignitor is a $35 part and a 20-minute job; total flat-rate runs $185-$340.
Heat pump no-heat in cold weather usually means failed reversing valve solenoid (system stuck in cool mode) or failed defrost board (outdoor coil iced up). Both diagnoseable in under an hour.
Older furnaces (15+ years) develop heat exchanger cracks. We check for them every diagnostic visit because a cracked heat exchanger leaks carbon monoxide and is a replacement-not-repair issue.
What it costs
Diagnostic visit runs $80 – $120. Hot surface ignitor replacement runs $170 – $315. Flame sensor replacement runs $150 – $270. Pressure switch replacement runs $200 – $385. Control board replacement runs $385 – $780. Heat exchanger replacement runs $1,655 – $3,130.
What's specific about Arlington jobs
If you're inside the city limits, we're typically there inside an hour during business hours. Outside the metro, plan on a bit longer.
On bigger jobs we'll bring two techs. On simpler ones, just one — fewer hands, faster billing.